Run flat tyres explained: pros, cons and can you switch to normal tyres?
If you drive a BMW, a Mini or another car without a spare wheel, there is a good chance you are on run flat tyres. They keep going for a while after a puncture, but they cost more, ride harder and usually cannot be repaired.
This article explains how run flat tyres work, how to recognise them, and what is involved if you want to switch to normal tyres in the Netherlands.
By the team at Autobedrijf Willemsbrug, RDW-approved APK (MOT) test station since 1979 · Updated 8 November 2026
Our score is 4.8 / 5 from 235 reviews. Read what our customers say
Our team speaks English, on the phone too. Have your registration number (kenteken) ready. We tell you one price in advance and when you can bring the car. Open Monday to Friday 8.00 to 17.30, Saturday 9.00 to 15.00.
The short answer
A run flat tyre has a reinforced sidewall that keeps carrying the car after the air has gone. According to Continental and Bridgestone you can then drive up to 80 km at no more than 80 km/h to reach a garage.
A tyre pressure monitoring system (TPMS) is a condition for run flat tyres, and they are usually replaced rather than repaired after a puncture. Switching to normal tyres is possible, but only as a full set of four, with a repair kit or spare wheel on board and with your car manufacturer’s advice in hand.
What is a run flat tyre and how does it work?
A run flat tyre is a tyre that can still cover a limited distance with no air in it. The secret is in the sidewall. On a normal tyre the air pressure carries the weight of the car.
When the tyre goes flat, the rim drops onto the road and the sidewall folds double. A run flat tyre has a self-supporting, reinforced sidewall of thick rubber. That holds the car up when the pressure is lost, so the tyre does not come off the rim and you keep control of the steering.
Manufacturers quote the same limits. Continental writes that after a loss of pressure you may continue for 80 km at a maximum of 80 km/h. Bridgestone gives the same values for its RFT tyres: up to 80 km at no more than 80 km/h. That distance is meant to get you to a garage, not to finish your journey.
Your owner’s manual gives the limit that applies to your car, and it can be lower when the car is heavily loaded.
Because you can barely feel a flat run flat tyre through the steering wheel, a tyre pressure monitoring system (TPMS) is a condition for this type of tyre. Bridgestone states that run flat tyres, whatever the system, may only be used on a car with TPMS.
The system warns you on the dashboard as soon as a tyre loses pressure. Without that warning you would drive too far and too fast and damage the tyre beyond repair.
How to recognise run flat tyres: RSC, SSR, ZP and other markings
You recognise a run flat tyre by an abbreviation on the sidewall. Each tyre manufacturer uses its own code. Uniroyal (part of Continental) lists RFT, CSR, DSST, HRS, EMT, ROF, SST, ZP and XRP as common abbreviations, alongside its own marking SSR.
Sometimes there is also a letter F in front of the rim size, for example 205/55 RF 16, or a small symbol that looks like a snail. BMW uses a circle with the letters RSC.
| Marking | Meaning | Found on |
|---|---|---|
| SSR | MeaningSelf Supporting Runflat | Found onContinental, Uniroyal |
| RSC | MeaningRunflat System Component | Found onBMW and Mini (tyre made specifically for BMW), also on Pirelli and Bridgestone tyres |
| ZP | MeaningZero Pressure | Found onMichelin |
| RFT | MeaningRun Flat Tyre | Found onBridgestone |
| ROF, EMT, DSST | MeaningRunOnFlat, Extended Mobility Technology, Dunlop Self Supporting Technology | Found onGoodyear, Dunlop |
| HRS | MeaningHankook Runflat System | Found onHankook |
| RF before the rim size, snail symbol | MeaningRun flat according to the European marking | Found onVarious brands |
Abbreviations according to Uniroyal (Continental) and the BMW owner’s manual. If in doubt, check your owner’s manual or call us with your registration number.
A BMW or Mini on run flat tyres usually has no spare wheel and no jack on board. That is the first clue. The BMW owner’s manual states that no spare wheel is available in the event of a flat tyre and that BMW recommends fitting run flat tyres again when you buy new tyres and at the seasonal change.
What are the pros and cons of run flat tyres?
The biggest advantage is that a puncture does not leave you standing on the hard shoulder of the A16. You drive on carefully to a safe place or to the garage. In return you pay more and give up some comfort.
| Advantage | Disadvantage |
|---|---|
| No wheel change in a dangerous spot (Bridgestone) | DisadvantageA run flat tyre is heavier, about 300 grams per tyre according to Uniroyal, and costs more to buy |
| No spare wheel needed, which according to Continental saves about 80 litres of boot space | DisadvantageThe stiff sidewall gives less cushioning. Many drivers feel bumps and manhole covers more strongly |
| After a blowout the car stays on course better (Bridgestone) | DisadvantageAfter a puncture most manufacturers advise replacement rather than repair (Continental) |
| Fitting and changing work the same as with a standard tyre (Continental) | DisadvantageYou need a car with TPMS and the choice of sizes and brands is smaller |
Sources: Continental, Bridgestone and Uniroyal, consulted 6 November 2026.
In the workshop we see one more drawback. A run flat tyre does not show clearly that it is flat. Anyone who ignores the dashboard warning drives further than the 80 km the manufacturer allows. The sidewall then overheats and breaks down from the inside. Such a tyre cannot be saved, even if the puncture itself was small.
Can a punctured run flat tyre be repaired?
Usually not. Continental writes that most manufacturers advise against repairing run flat tyres. BMW recommends in the owner’s manual that damaged run flat tyres are replaced, not repaired.
Uniroyal says the same about tyres that have been driven on without pressure. The reason is that the reinforced sidewall can be damaged on the inside after a drive without air, without you seeing anything on the outside.
That is why we do not repair run flat tyres. We replace a punctured run flat tyre with a new one. How we assess a normal tyre is explained in our article on puncture repair or replacement. There the Continental rules apply: only a hole smaller than 6 mm in the central three quarters of the tread.
Can you replace run flat tyres with normal tyres?
Yes, technically it is possible. According to Continental, run flat tyres fit standard rims, so the reverse also applies: a normal tyre fits the rims of a car that was delivered with run flats. The Dutch APK (MOT), the compulsory Dutch vehicle inspection, sets no requirement for run flat tyres. There are, however, a few conditions you cannot avoid.
- As a full set of four. Uniroyal writes that a car must be either on run flat tyres or on standard tyres, and not mixed per axle either. A run flat tyre reacts differently in a corner and in an emergency stop than a normal tyre.
- Arrange something for a puncture. Without run flats you have no back-up when a tyre goes flat. Carry a tyre repair kit or a space-saver spare. Read our article on tyre repair kit, space-saver or spare wheel.
- The TPMS keeps working. The sensors sit on the rim, not in the tyre. After fitting and inflating, the car usually learns the new tyres after a short drive, or you reset the system in the menu.
- Read your manufacturer’s advice. BMW recommends that you keep fitting run flat tyres for your own safety. That is not a legal obligation, but it is in your owner’s manual. Also read the terms of your warranty or lease contract.
- Same size, load index and speed rating. The new tyre must meet the same requirements as the original. How to read those codes is explained in tyre size explained.
Many owners choose normal tyres for the comfort and the price. Others keep run flats because they drive a lot and do not want to change a wheel. Both choices can be defended. What does not work is mixing run flat and normal tyres, or switching without arranging anything for a puncture.
Run flat tyres replaced in Rotterdam: how it works with us
We supply and fit run flat tyres of all brands, and also normal tyres for cars that were delivered with run flats. You call us with your registration number (kenteken).
We look up the sizes approved for your car, check the load index and the speed rating, and tell you one price in advance. That price includes the tyres, fitting, balancing and disposal of the old tyres. If anything needs adding, we tell you first.
A run flat tyre needs care when it is fitted. The stiff sidewall has to go over the rim edge with the right tyre machine and enough lubricant, otherwise the bead of the tyre is damaged. Our mechanics do this regularly on BMW, Mini and Mercedes-Benz.
At every fitting we balance the wheels and check the tyre pressure and the TPMS. We only recommend alignment when there is a reason for it, such as uneven wear or a steering wheel that sits off-centre. Everything about our tyre service is on the page tyre replacement and seasonal changes in Rotterdam.
You bring the car Monday to Friday between 8.00 and 8.30 am or by appointment, or on Saturday at 9.00 am. Waiting while the tyres are fitted is not possible. We call you when the car is ready. A loan bike is free while one is available.
Read more
Frequently asked questions
Sources
- Continental: Runflat tyres (SSR): 80 km at a maximum of 80 km/h (opens in a new tab)
- Bridgestone: Run Flat Tyres: How They Work (opens in a new tab)
- Uniroyal (Continental): Self Supporting Runflat (SSR): markings, TPMS and mixing (opens in a new tab)
- Continental: Tire repair: when can a tire be repaired? (opens in a new tab)
- BMW: BMW 3 Series owner’s manual, run flat tyres (RSC) (opens in a new tab)